How to Clean the Stainless Steel Watch Band?

Stainless steel straps are sturdy and reliable, and seem to be easier to handle than leather straps. In fact, this is not the case. The crevices of stainless steel watchbands are easy to accumulate dirt and are not easy to clean. Long-term accumulation will not only make the watchband lose its original metallic luster, but also breed a lot of bacteria, which is harmful to health. So how do you clean the stainless steel watch band? Below we will teach you two ways to easily clean the steel watch band.

1. Cylinder method cleaning stainless steel watch band

This method does not need to disassemble the watch band. Be careful when cleaning, and try not to splash water on parts other than the watch band.

1) Stack the plastic wrap and the magazine together and roll them together into a cylinder to prevent the magazine from getting wet when cleaning the strap.

2) Put the watch on the rolled cylinder. The cylinder is enlarged until the strap is fully extended so that the watch will not fall off.

Note: Cleaning stainless steel watch band in this way is for the convenience of cleaning for a while, and more importantly, after opening the watch band, you can clean the stains in the gap of the watch band.

3) Clean the strap carefully with a toothbrush

4) After filtering with clean water, wipe it clean with a soft cloth.

Note: Do not expose to the sun. Will damage the quality of the strap.

Rinse carefully with clean water. If you still can't clean it up, you can apply a little toothpaste, and use hand sanitizer or soap to scrub the stains with a toothbrush.

When the cylinder cannot open the gap between the strap joints, after removing the strap, we can try another method to clean the stainless steel strap.

2. Cleaning stainless steel watch band by immersion method

1) Soak the strap in boiling water with detergent for about 15 minutes. Using the principle of thermal expansion and contraction, the gap between the joints is slightly opened, so that it can be cleaned.

2) Clean the strap carefully with a toothbrush.

3) Soak the strap in cold water for about 15 minutes. In this way, the detergent on the watch band can be soaked clean, and the opened gap can be restored to its original shape.

4) Take out the strap and wipe it clean with a soft cloth.