What Are the Tools for Repairing a Wrist Watch? What Do They Do?

A watch is a precise timing tool, and it is a complicated and difficult process to repair a watch. For ordinary people, maybe some tools you don't know what to do? Let's take a look at the tools for repairing watches one by one.

Ⅰ. Eyepieces of wrist watchs and how to use them

1. Use: Due to the delicate parts of the watch, each component must be seen through a magnifying glass. Usually it is necessary to prepare magnifying glasses with different magnifications of 3 to 12 times. Low magnifications are mostly used for parts disassembly and assembly, while high magnifications are used to adjust the hairspring and check whether the core is skewed or extremely small parts.

2. Usage: You can directly open the upper and lower eyelids to clamp the magnifying glass, or you can use iron wire or buy a ready-made iron wire ring, put the magnifying glass tightly and then put it on the head. The length of the iron wire can be adjusted by yourself, and people who wear glasses with myopia can Can be used directly on the mirror surface.

Ⅱ. The strap support of wrist watch

1. Purpose: A support seat used to fix the hand watch strap to facilitate disassembly when adjusting the length of the watch strap.

2. Usage: Place the strap thimble vertically at the movable pin of the movable watch section in the direction of the arrow, tap it with a hammer, and the movable pin will be disengaged. After adjusting to an appropriate length, it can be put back on the other side in the same way.

Ⅲ. The dismantling knife of the wrist watch

1. Use: Open the bottom cover of the watch.

2. Usage: Hold the hand watch firmly to avoid slipping and cutting the back cover. Use the watch-opening knife to press in and pull it up from the edge of the back-bottom cover. There is a shorter knife at the other end of the watch-opening knife, which can be used for belts. Watch strap removal. Note: It is only applicable to the press-fit case back design, and a special watch opener must be used for screw-on case backs, locking screw casebacks or special casebacks.

Ⅳ. The opener of wrist watch

1. Purpose: Open the screw-in rear bottom cover.

2. Usage: There is a rotary knob at the rear end for adjusting the size. After adjusting the watch opener to the appropriate size of the watch, press and turn it to the left to open the back bottom cover. It is better to use it with the watch holder. smoothly.

Ⅴ. The wind ball of wrist watch

1. Purpose: to remove dust from parts.

2. Usage: Just hold and press for a few times.

Note: After the hand watch is assembled and oiled, avoid blowing at the oil hole to avoid the oil in the oil hole being blown away.

Ⅵ. Brush and stain removal oil pan of wrist watch

1. Use of the brush: It is used for brushing parts when washing oil, and it can be dried in the shade after use.

2. Use of stain removing oil pan: To hold the parts that need to be washed, add stain removing oil to the pan, and then use a brush to clean the parts

Ⅶ. The movement fixed seat of the wrist watch

1. Use: There are two sizes of bases for men's and women's watches, which are used to fix the movement and facilitate disassembly.

2. Usage: Place the outer ring of the movement smoothly in the groove of the fixed seat, lock it gently, and do not use too much force, so as not to hurt the machine board.